What's the difference between Compression Molding and Liquid Injection Molding? Liquid silicone injection molding (LIM) is an injection molding method of liquid silicone rubber(LSR), which uses High Consistency Rubber (HCR) that is also called gum stock, and LIM uses a high viscosity liquid silicone rubber.

What is cycle time?Cycle time is the total time required to complete all the stages of the injection molding cycle.The cycle time is made up of the following stages:Fill time.The time required to fill the mold with polymer. The injection molding machine controls the velocity (flow rate) of the molte

Silicone Molding, also known as silicone compression molding or rubber compression molding, is a very common processing technique for manufacturing silicone rubber parts, which is feeding solid silicone raw material mixed with vulcanizing agent in the mold, through a certain period of high temperatu

Liquid Silicone Injection Mold without Shut-off ValvesLiquid silicone injection mold without shut-off valves, similar to edge-injection-gate plastic injection mold. Because Liquid silicone & lsr products by silicone injection molding without shut-off valves will have big injection gate mark or flow

oid air stagnation, it is important to have a good exhaust device in the mold. In addition, LSR materials do not shrink like thermoplastic in the mold. Liquid Silicone Rubber tend to expand when be heated and will shrink slightly when be cooled. Therefore, the product does not always stay on the con

Liquid Silicone Rubber also called as Liquid Silicone, LSR, Clear Silicone Rubber Liquid, LSR Silicone, which can be divided into Food Grade Liquid Silicone and Medical Grade Liquid Silicone. For common Liquid Silicone Rubber, that can achieve Food Grade, and if need to achieve complete 100% Medical

Unlike rigid machined materials, thermoset molded elastomers do not lend themselves well to the same level of tolerancing. Being thermally molded, elastomers are subject to many variables. Temperature, cure time, mold tolerance, mold registration, compound variation, and shrinkage are just some of t

What is Liquid Injection Molding Simulation (LIMS)?