Rubber To Metal Bonding & Rubber To Metal Overmolding process is to vulcanize elastomer rubber materials in-mold attaching various metal substrates with pre-coated glue/primer/adhesive preparation, such as stainless steel, brass, aluminum, etc, which are commonly used for these application below:1)
oid air stagnation, it is important to have a good exhaust device in the mold. In addition, LSR materials do not shrink like thermoplastic in the mold. Liquid Silicone Rubber tend to expand when be heated and will shrink slightly when be cooled. Therefore, the product does not always stay on the con
Compression molding is one of the most tranditional and oldest silicone rubber manufacturing technique. Silicone Compression molding has been used to mold silicone rubber parts at the beginning of the rubber manufacturing industry. Silicone compession molding’s main process parameters are: molding t
LSR Silicone Buttons is made of transparent food grade liquid silicone. Liquid rubber keypad can be silkscreen printed or laser engraved with different patterns. Conductive LSR rubber buttons are very durable, with good wear resistance and heat resistance. LSR button pad also has a good backlight effect for good transparency of liquid silicone material.
This seal, sometimes called a Flapper Seal sit right at the bottom of the Flush Valve. This valve discharges water from the cistern tank when you push the button, turn the handle...etc. Its job is to hold back about 6 litres of water, ready to flush.
What is transfer molding? Transfer molding is a combination of compression molding and liquid silicone injection molding. Transfer molding considered as a simplified variation of injection molding, and the process has much in common with earlier iterations of injection molding before the introductio